index
More than wood: Your strong B2B partner Get advice now without obligation
Special offers / Remaining stock
Special offers / Remaining stock

Deck joint tape

Terrace joint tape for wood and WPC decks in black. Available for joint widths of approx. 4 mm and approx. 7 mm, each as a 50 m roll. For the visual closure of joints between decking boards.

2 products

Now available at Gunreben.de in the usual top quality:

Deck joint tape for wood and WPC decking

With a deck joint tape, the gaps between decking boards can be visually closed. At Gunreben, you will find black joint sealing tapes for joint widths of approx. 4 mm and approx. 7 mm. The appropriate version depends on the existing gap spacing of your decking boards.

The products are also searched for under terms such as joint sealing tape for decks, WPC joint tape, or WPC gasket. However, the decisive factors for selection are the joint width that matches the deck system and compliance with the product-specific installation instructions.

Which deck joint tape is right for my deck?

For decks with a gap spacing of about 4 mm, the corresponding 4 mm version is available. For a gap spacing of about 7 mm, the 7 mm version is used. Both variants are black and are offered as a 50 m roll.

Before selection, the existing joint width should be checked at several points on the deck. Especially with wooden decks, possible dimensional changes of the boards as well as the specifications of the respective deck system must be taken into account.

Installation of the joint sealing tape

The joint sealing tape is inserted into the joint after the decking boards have been laid. The tape should not be stretched or pulled lengthwise when being pressed in, as it may subsequently contract.

For every linear meter of joint length, about 10 mm of additional length should be planned for and initially left to overhang at both ends. Due to temperature-related changes in length, the overhanging ends should only be trimmed later in accordance with the product-specific installation instructions.

Consider substructure and ventilation

For the use of the joint sealing tape, the spacing of the substructure timbers should be a maximum of 400 mm. With larger spacings, increased deflection of the decking boards can cause the tape to be pushed out of the joint.

In addition, sufficient ventilation underneath the deck floor is required. For these joint sealing tapes, an under-ventilation of at least 8 cm is intended.

FAQs

A deck joint strip is inserted into the gap between decking boards and serves to visually close the gap. Depending on the product, it is also referred to as joint sealing tape, WPC joint strip, or WPC seal.

The version depends on the actual distance between the decking boards. The 4 mm version is intended for gaps approximately 4 mm wide, and the 7 mm version for gaps approximately 7 mm wide. The gap width should be checked in several places before ordering.

The available versions are intended for suitably appropriate wood and WPC decks. In this context, the gap width and the product-specific requirements of the respective deck construction must be taken into account.

The strip is pressed into the gap after the decking boards have been laid. It should not be stretched or pulled lengthwise. Approximately 10 mm of additional length should be planned for per linear meter.

There should be a ventilation space of at least 8 cm beneath the deck floor. When using the joint sealing tape, the spacing of the substructure beams should be a maximum of 400 mm.